2016 is the year where most of the people would be looking for the devices with fingerprint sensors on it for the security reason. There are many brands available in the market, and all of them have already started designing the devices with a fingerprint sensor on it, and Motorola Atrix was the first device to comes with a fingerprint sensor on it. Though the device comes with a fingerprint sensor on it, there is a restriction where you can add only limited impression on your device. I have come up with an idea where you can speed the fingerprint sensor of your device and can unlock your device by adding a single impression on your device.
How to add a Fingerprint sensor on your device?
Adding a fingerprint and securing your device is just a simple process. This is the general method applicable for all the device with a fingerprint option on it.
Step 1: Before you add a fingerprint you need to setup a recovery password for your device which may be a Pattern, Pin or Alpha-Numeric password.
Step 2: Once you are done with the password setup, open the settings and tap on Security where you can find the fingerprint option. In few Chinese devices, this option is directly available on the settings window or in the App drawer on their smartphones.
Step 3: Now you need to place the finger on the sensors and follow the on screen instruction where you device vibrates for every impression, you just need to lift the finger and press it again. This process repeated until the thumb, or the fingerprint is completely capture.
Once you are done with this, a success message is displayed and further it will ask for set the fingerprint lock, tapping on that will enable the fingerprint unlock option on your device.
Note: In few device you need to configure the password after adding the fingerprint on your device which is always an Alpa-Numeric Password.
Speed Up your Fingerprint Sensor
This is the process of adding a fingerprint on any smartphone. Sometimes you are busy with one hand and would like to unlock your device, but you have set the fingerprint on the active hand, then it would create a mess while unlocking your device. So I have a trick where you can unlock your device using all the fingers on your device. You need to follow the steps mentioned below to speed up the fingerprint sensor on your device.
Step 1: Firstly, open the Fingerprint option and delete all the existing fingerprints on your device.
Step 2: Now click on Add a Fingerprint and start adding the impressions of all the fingers on your device.
Note: Adding all the fingers is not a problem but sometimes it may delay while recognising the impression on your device. So you can follow the next step which will boost the fingerprint speed on your device.
Step 3: Instead of adding all the fingers you need to select two fingers. Suppose if you are going the thumb impressions of both the hands, then add 40% of each thumb and the remaining 10% with the impressions of the Tip.
Once you are done with the above-mentioned setup, you can easily unlock your device without any disturbance.